Oberdorfer model # 172B-B27 - Centrifugal Pump & Motor Assembly

Oberdorfer Pump 172B-B27

Oberdorfer # 172B-B27

Oberdorfer catalog # 172B-B27, Centrifugal Pump and Motor Assembly, 18 GPM, Buna Mech Shaft Seal, c/w 1/8 HP, c/w, 230 Volts, TEFC (Totally Enclosed Fan Cooled) Electric Motor. 3/4" x 3/4" Internel NPT Ports.

Price : $ 1042.75

 

Product Information :

Features :

Pump Body:
Bronze
Impeller:
Mechanical Seal Buna-N
Port Size:
3/4" x 3/4" Internel NPT

Parts and Accessories for Oberdorfer model 172B-B27


Pump less Motor / Replacement Pumphead :

Catalog # 172B, Centrifugal Pump End Only (no motor) 18 GPM, Buna Mech Shaft Seal, close coupled Pump End Only for Electric Motor mount. 3/4" x 3/4" Internel NPT Ports.

Price: $ 261.90


Pump Service Kit :

Catalog # 11071, +REPAIR KIT FOR 172B. Includes : Gasket, Impeller, Buna Mechanical Seal Assembly

Price: $ 108.07


Impeller :

Catalog # 7678, BRONZE IMPELLER

Price: $ 64.64


Shaft Seal :

Catalog # 32458, SEAL ASSY FOR 172A & 172B

Price: $ 63.63


Motor :

Catalog # 8282, MOTOR IGNITION PROOF 1/8 HP

Price: $ 838.30


Other Parts :

Catalog # 7020, Gasket

Price: $ 14.14

Applications

Features • Rugged corrosion resistant bronze construction • Compact and light Applications One of the outstanding features of this pump and motor unit is its compact size. Although small, adequate motor power is available for pumping water, water solutions, and a wide range of commercial chemicals. Questions about the chemical compatibility of special liquids should be referred to the factory. These Oberdorfer centrifugal pumps have a single open vane rotating impeller. Liquid enters at the center and is thrown outward radially by centrifugal force. The impeller is not in contact with other pump parts resulting in quiet, efficient pumping action. The flow produced is not positive which permits the discharge line to be shut off completely without danger of overloading motors or bursting lines. Consequently, a relief valve is not required. These pumps are not selfpriming. They must be installed below the liquid level so that the liquid flows to the pump by gravity flooded suction.