Oberdorfer model # 170M-A95 - Centrifugal Pump & Motor Assembly
Product Information :
Features :
Parts and Accessories for Oberdorfer model 170M-A95
Pump less Motor / Replacement Pumphead :
Catalog # 170M, Bronze Centrifugal Pump end only, no motor, Bronze construction, Bronze impeller, Buna Lip Seal. Inlet Port is 3/4 Inch NPT Inlet, Discharge Port is 3/4 Inch NPT Outlet.
Price: $ 536.26
Pump Service Kit :
Catalog # 10911, Repair Kit (164M/170M)
Price: $ 204.00
Impeller :
Catalog # 7678, Impeller
Price: $ 136.00
Shaft Seal :
Catalog # 6647, Lip seal
Price: $ 57.73
Other Parts :
Catalog # 7020, Gasket
Price: $ 14.03
Applications
Features • Rugged corrosion resistant bronze construction • Compact and light Applications One of the outstanding features of this pump and motor unit is its compact size. Although small, adequate motor power is available for pumping water, water solutions, and a wide range of commercial chemicals. Questions about the chemical compatibility of special liquids should be referred to the factory. These Oberdorfer centrifugal pumps have a single open vane rotating impeller. Liquid enters at the center and is thrown outward radially by centrifugal force. The impeller is not in contact with other pump parts resulting in quiet, efficient pumping action. The flow produced is not positive which permits the discharge line to be shut off completely without danger of overloading motors or bursting lines. Consequently, a relief valve is not required. These pumps are not selfpriming. They must be installed below the liquid level so that the liquid flows to the pump by gravity flooded suction.