Jabsco part # 96080-0290

The Jabsco 96080-0290 is a service kit, with Viton impeller, seal and o-ring for a Jabsco rubber impeller pump. MECHANICAL SEAL REPLACEMENT
1. Remove wing nuts, washers and end cover. 2. Remove pump head from seal housing. Remove O-rings from body grooves. 3. Push impeller from body bore. 4. Remove seal housing. Insert screwdriver through seal seat bore and pry seat and grommet from seal housing. 5. Remove drive sleeve from shaft. Remove seal and seal spring from drive sleeve. 6. Install seal spring on drive sleeve. Lubricate seal with water and slide on drive sleeve with carbon facing away from spring. Install drive sleeve on shaft. 7. Install ceramic seal seat in grommet with grooved face towards grommet. Lubricate outer grommet surfacer with water and push seal seat assembly into seal housing with ceramic seals facing out of seal seat bore. Assemble seat housing over through bolts so seal and seats faces contact. 8. Assemble impeller body and end cover as in steps 4, 5, and 6.