Jabsco # 28230-2223 Stainless Steel Flexible Impeller Pump

The Jabsco 28230-2223 is a 316 stainless steel Flexible Impeller pump with a high pressure Nitrile Impeller, Nitrile/Tungsten Carbide/Ceramic Mechanical Seal, 3/4 Inch BSP Ports, bare shafted pedestal pump end only without a Motor. These pumps can be used where single or variable speed operation and 316 Stainless Steel material is desirable. These pumps are self-priming, with a 10.6 GPM (40 LPM) flow and are debris-tolerant. These pumps are self-priming and will prime at low or high speeds. For a vertical dry suction lift of 10 feet (3m) a minimum of 860 RPM is required. Pump will produce suction lift up to 16.4 feet (5m) when wet. Be sure suction lines are airtight or pump will not self-prime. This unit depends on the liquid pumped for lubrication. Do not run this pump dry for more than 30 seconds as a lack of liquid will damage the impeller. The operating temperature limits of the pump depend on the impeller compound. The following ranges apply for Nitrile impellers : 50 degrees F to 180 degrees F (10 degrees C to 82 degrees C). A nitrile impeller is ideal for oil-based products. The tungsten carbide seal in this pump is good for when pumping highly-corrosive or abrasive fluids. Qty Part Number .