Jabsco # 22610-2007 Ballast King DC Flexible Impeller Pump

Jabsco Pump 22610-2007

Jabsco # 22610-2007

Jabsco catalog # 22610-2007, Ballast King DC Flexible Impeller Pump and Motor unit with BSP Ports. Pump is Close Coupled to a 12 Volt DC Motor. Ports are 1 Inch hose barb and 1/2 Inch BSP internal Threaded.

Price : $ 536.66

Qty :

2 Weeks (0 in stock)

Click Here for PARTS


Product Information :

The Jabsco 22610-2007 is a ballast king dc flexible impeller pump coupled to a 12 Volt DC Motor. This model does NOT include the Reversing Polarity Switch. This is the higher flow version of the Ballast Puppy. Featuring a larger motor, the Ballast King will pump up to 15 GPM (57 LPM), which will add up to 125 pounds of ballast water per minute. It's reversible, so it can both empty and fill ballast tanks. It's self-priming and the impeller is run dry. Only the model 22610-9507 has a Reversing Polarity Switch that is part of the motor. Maximum ambient temperature is 60 degrees C (140 degrees F), with minimum temperature - 15 degrees C (5 degrees F). The pump should be installed so that the motor is protected from constant rain, wash down or bilge water. The pump should not be run with a closed outlet. The pump body can be turned 180 degrees in relation to the motor. This will change the flow direction. Only use the pump with specified products, including fresh and salt water solutions.

Do not use any Jabsco pump for petrol, petroleum products or any products with a flash point below 37 deg. C, .

Features :

Port Size:
Ports are 1 Inch hose barb and 1/2 Inch BSP internal Threaded

Product Specs :

Product Specs :

Parts and Accessories for Jabsco model 22610-2007


The pump has been designed to pump fluid into ballast tanks. Utilizing Jabsco's reversible flexible impeller pump technology, ballast systems can be filled or emptied with the new Ballast King 15 GPM. When required, the pump is switched on to fill the tank then the pump switched off when full. To reduce ballast, the pump will reverse to pump ballast back over board. The same operation is used for ballast transfer between two tanks. The pump can be mounted on any flat suitable surface. Fit the pump in a dry, well ventilated position where there is full access for service. Use rubber grommets provided to minimise vibration, do not over tighten the mounting screws. All marine pumps discharging overboard must be installed with the overboard discharge well above both static and heeled waterlines.