Jabsco # 17430-0004 Epoxy Utility Pump 1/2 HP

The Jabsco 17430-0004 is a glass-filled epoxy Flexible Impeller pump with a Viton Impeller, Viton/Carbon/Ceramic Mechanical Seal, 1/2 Inch NPT Internal Ports, coupled to a 1/2 Horsepower, 1725 RPM, 115 Volts AC, 1 Phase, TEFC, 60 HZ Motor, with a 8 Foot cord Three-pronged Grounded Plug. These pumps can be used where corrosion-resistant phenolic or glass-filled epoxy material, self-priming and debris tolerance are desired. These pumps have an open flow of 11 GPM (42 LPM) flow, are self-priming and will prime at low or high speeds. This pump has a vertical dry suction lift of 3 feet with the Viton impeller. Pump will produce suction lift up to 20 feet when wetted. Be sure suction lines are airtight or pump will not self-prime. The Viton impeller in this pump is good for Chemicals, hydrocarbons and solvents. Temperature limits for Viton impeller are 60 degrees to 180 degrees F (15 degrees to 82 degrees C). Pump may be mounted in any position. Inlet port is on the right and discharge port on the left when facing pump. This unit depends on liquid pumped for lubrication. Do Not Run Dry for more than 30 seconds. Lack of liquid will damage the impeller and the pump components.