Burks Pump T15WA6AB Self Priming Centrifugal Pump and motor

The Burks T15WA6AB is a Self Priming Centrifugal Pump and Motor, with All Bronze construction, Bronze casing, diffuser, motor adapter and impeller, a 5.44 Inch Bronze Impeller, 303 Stainless Steel shaft, Buna Mechanical Seal and suction sleeve, 1-1/2 Inch NPT Suction x 1-1/2 Inch NPT Discharge, and is close coupled to a 1-1/2 Horsepower, 3500 RPM, 60 HZ, 115/230 Volt, 1 Phase, TEFC (Totally Enclosed Fan Cooled) 56J frame Motor. The Burks WA6 Series pumps are close coupled self priming centrifugal pumps, 3500 RPM, 60 HZ, 1 to 3 HP, for lawn sprinkling, pressure boosting, sprinkler systems, light irrigation, dewatering clean liquids and transfer from underground storage. Fast priming, the pump stays primed; flapper and check valves on the suction pipe are not required but are recommended. The cast iron casing has suction, discharge, prime, vacuum gauge and drain tappings; the standard impeller is glass filled Noryl with a molded-in brass insert, and all bronze or all iron construction is available. A leak proof, self adjusting mechanical shaft seal; continuous duty 56J frame motors, single phase ODP and TEFC motors with built-in overload protection, three phase motors to be installed with a magnetic starter. Non-overloading performance at all catalog ratings; maximum inlet pressure 100 PSI, casing working pressure 200 PSI, 175 degrees F maximum with the standard Noryl impeller; every pump is factory tested and meets Hydraulic Institute standards. This pump is All Bronze construction, close coupled to a 1-1/2 Horsepower, 3500 RPM, 60 HZ, 115/230 Volt, 1 Phase, TEFC (Totally Enclosed Fan Cooled) 56J frame Motor. It uses a Carbon/Ceramic/Buna mechanical seal with a Buna suction sleeve. Suction and discharge connections are 1-1/2 Inch NPT Suction x 1-1/2 Inch NPT Discharge.