Burks 33GV6-36 Simplex Condensate Return System

The Burks 33GV6-36 is a Simplex Condensate Return System, with a GV6 bronze fitted flange mount pump, 3.22 Inch Bronze Impeller, Carbon/Ceramic/Buna mechanical seal, a 36 gallon Cast Iron receiver and a heavy duty adjustable float switch with stainless steel float and rod, 3 Inch NPT Receiver Inlet x 1-1/4 Inch NPT Discharge, close coupled to a 1/3 Horsepower, 3500 RPM, 60 HZ, 230/460 Volt, 3 Phase, ODP (Open Drip Proof) 56J frame Motor. Burks GV Series condensate return systems, 3500 RPM, 60 HZ, for gravity return systems: cast iron receiver tanks for lifetime service under severe conditions, with a low return inlet, in 9, 14, 20 and 36 gallon sizes. The pumps are vertically flange mounted centrifugal pumps of bronze fitted construction with a mechanical shaft seal for temperatures to 225 degrees F; the seal area is automatically vented and flushed, back pull-out design allows servicing without disturbing the piping, and the bronze impellers are precision balanced for smooth, quiet operation and non-overloading performance at every rating. Drip-proof NEMA motors have dual ball bearings and a threaded stainless steel shaft; single phase motors have built in overload protection, three phase motors must be installed with a magnetic starter. Simplex systems carry a heavy duty adjustable float switch with stainless steel float and rod, duplex systems a mechanical alternator. Factory assembled and prewired, and every pump is factory tested. Receiver tanks are for gravity return only and are not to be pressurized; vent the tank to atmosphere, 1-1/4 inch minimum. This unit is a Simplex system, a GV6 bronze fitted flange mount pump on a 36 gallon cast iron receiver with a heavy duty adjustable float switch with stainless steel float and rod, close coupled to a 1/3 Horsepower, 3500 RPM, 60 HZ, 230/460 Volt, 3 Phase, ODP (Open Drip Proof) 56J frame Motor. Connections are 3 Inch NPT Receiver Inlet x 1-1/4 Inch NPT Discharge.