Burks Pump 20GV6-1-1/4FCME Centrifugal Pump and motor

The Burks 20GV6-1-1/4FCME is a Centrifugal Pump and Motor, with Bronze Fitted construction, Cast Iron casing and motor adapter, a 4.88 Inch Bronze Impeller, 303 Stainless Steel motor shaft, Bronze casing wear ring, EPT Mechanical Seal, Square Flange Inlet x 1-1/4 Inch NPT Discharge, and is close coupled to a 2 Horsepower, 3500 RPM, 60 HZ, 115/230 Volt, 1 Phase, ODP (Open Drip Proof) 56J frame Motor. The Burks GV6 Series pumps are flange mount centrifugal pumps, 3500 RPM, 60 HZ, 1/3 thru 3 HP, with capacities to 80 GPM and heads to 130 feet. The flanged and gasketed inlet mounts to a tank or any flat surface, and the pump may be installed vertically or horizontally; it is the replacement pump on Burks Series GV condensate return systems. Bronze fitted, close grain cast iron construction: an enclosed bronze impeller threaded onto the stainless steel motor shaft and balanced for smooth, quiet operation, and a replaceable bronze casing wear ring. Back pull-out design means the casing stays in place for service. The self adjusting mechanical shaft seal is rated to 225 degrees F and 150 PSI, with tappings for venting and flushing the seal area. Motors are 56 frame NEMA flange with a one piece threaded stainless steel shaft and ball bearings; ODP motors carry a drip cover for vertical installation. Maximum inlet pressure is 100 PSI and casing working pressure 200 PSI; every pump is factory tested. This pump is Bronze Fitted construction, GV6-1-1/4 size, close coupled to a 2 Horsepower, 3500 RPM, 60 HZ, 115/230 Volt, 1 Phase, ODP (Open Drip Proof) 56J frame Motor. It uses a EPT mechanical seal with a EPT casing O-ring, for hot water or caustic service. Connections are Square Flange Inlet x 1-1/4 Inch NPT Discharge.