NOTE: Table above shows approximate performance for new pump with nitrile impeller pumping water.

• SELF-PRIMING: Pump will produce a suction lift approaching 10 feet (3m) when dry and a lift up to 22 feet (6.7m) when primed. Be sure suction lines are airtight or pump will not self-prime.
• RUNNING DRY: Unit depends on liquid pumped for lubrication. Do not run dry for more than 30 seconds. Lack of liquid will damage the impeller.
• PRESSURES: For continuous operation, pressure should not exceed 20 psi (1.4 kg/sq cm).
• TEMPERATURES: Nitrile impeller recommended for liquid temperatures of 50° to 180°F (10° to 82°C).

USES :

MARINE: Bait tank circulation, transfer oil, wash down, and utility dock pumps.

FARM: Fill tractor tires, fill water tanks, pump out silo pits, liquid manures, transfer oil, and flush and clean animal pens.

CONTRACTORS: Remove water from excavations, supply water to mortar boxes and cement mixing, and washdown equipment.

NOTICE: Do not pump solvents, thinners, highly concentrated or organic acids. Damage to pump may result. If corrosive fluids must be handled, pump life will be prolonged if pump is flushed with water after each use or after each work day.