Oberdorfer model # N994RL - Gear Pump

Oberdorfer Pump N994RL

Oberdorfer # N994RL

Oberdorfer catalog # N994RL, Gear Pump End with NEMA 213TC or 215TC Motor Bracket Only (no motor - for close coupled pump and motor assembly ) 10 GPM, Buna Lip Shaft Seal. *** c/w Internal Relief Valve ***. 1/2" inch NPT Ports.

Price : $ 1213.76

 

Product Information :

Features :

Pump Body:
Bronze
Impeller:
Lip Seal Buna-N
Port Size:
1/2" inch NPT

Applications

Features • Bronze Construction with Stainless Steel Shafts • Helical gears for quiet operation • Easy Field Assembly to Motors • SelfLubricating Carbon Bearings • Oring seal for maximum leak protection Applications These pumps are suitable for all liquids that are compatible with bronze. Most common liquids are water, oil, and mild chemicals in the pHrange of 4 to 11. Viscous liquids require reduced shaft speeds of 1150 RPM or lower. Consult factory. Liquids containing solids, abrasives, powders or paint pigments are definitely not recommended for gear pumps. If abrasives are unavoidable, use a very low shaft speed. The recommended liquid temperature range is 32 F to 140 F for longest pump life. If more extreme temperature conditions exist, our factory should be consulted. Freezing of waterfilled pumps can cause damage and must be avoided. Oils at low temperatures are very viscous requiring a lower speed or extra power. SUCTION LIFT As a general rule, the suction lift should be kept at an absolute minimum by placing the pump as close to the liquid source as possible. A gear pump in new condition can lift 20 feet of water in the suction line. A foot valve preferably with builtin strainer is recommended at the beginning of the suction line. For a first startup, the pump should be primed to avoid dry running. Minimum size of the suction pipe is the size of the pump inlet port. For longer suction lines over 3 feet, or for viscous liquids, the pipe size should be at least one size or two sizes larger than the pump inlet port.

ROTATION AND RELIEF VALVE The relief valve is not intended to be a metering or flow control device. Its main purpose is to function as a discharge pressure relief when the spring tension is exceeded by the discharge pressure. Overheating can occur within 510 minutes if the discharge line is completely shut off for extended periods. Unless otherwise specified, the pump motor unit is supplied by the factory for shaft rotation clockwise from shaft end. Reversing the motor rotation will reverse the in and out ports and also requires changing the relief valve location. The relief valve is always on the discharge side in this pump series. The factory pressure setting is 50 PSIG. To increase pressure, turn the relief valve adjusting screw in a clockwise direction. To reverse single phase motors, find instructions on the inside of the junction box cover or on the name plate of the motor. Three phase motors are not wired for any particular rotation. They can be reversed by interchanging any two 2 wires of the three 3 wire leads.