Jabsco model # P6-M6 - Motor Pump Unit

Jabsco # P6-M6

Jabsco catalog # P6-M6, Pump and Motor assembly, Neoprene Impeller, c/w 1/6 Horsepower, 115 Volt Single Phase, ODP (Open Drip Proof) Electric Motor. 5/8" OD for Hose barbs Ports. *** NOTE : This catalog number has been updated by the manufacturer, and will ship as the Jabsco Pumps catalog # 12290-0001.

Product Information :

Applications

NOTE Table shows approximate HeadFlow for new pump in U.S. Gallons and liters with Neoprene Impeller. Capacities reduced approximately 10 with Nitrile or Viton Impellers. &149; SELFPRIMING Vertical dry suction lift of up to 10 feet 3 m for neoprene; 5 feet 1.5 m for nitrile and viton. Pump will produce suction lift up to 15 feet 4.5 m when wetted. Be sure suction lines are airtight or pump will not selfprime. &149; RUNNING DRY Unit depends on liquid pumped for lubrication. Do not run dry for more than 30 seconds. Lack of liquid will damage the impeller. &149; PRESSURES For continuous operation, pressure should not exceed 15 psi 1.05 kg/sq cm. &149; TEMPERATURES Nitrile impeller recommended for liquid temperatures of 50 to 180F 10 to 82C.

USES Designed as a low cost pump for transfers, circulation, spill returns, filtration and filling line use. Easily handles pure solutions, foaming liquids, emulsions, suspended solids and ferments with viscosities less than 500 SSU 120 cp. Because the plastic pump is resistant to corrosion and metallic contamination, it is widely used for pumping photo chemicals, plating compounds, lab solutions, pharmaceuticals, cosmetics, weak acids, alkalies, liquid fertilizers, insecticides, dyes, detergents, waxes and many more. NOTICE Do not pump solvents, thinners, highly concentrated or organic acids. Damage to pump may result. If corrosive fluids must be handled, pump life will be prolonged if pump is flushed with water after each use or after each work day.