Jabsco model # 31750-0000 - Sensor Max VSD 14

Jabsco Pump

 

Features

Pump Body:
Glass Filled Polypropylene
Port Size:
Motor / Amp Draw:
, 12-24VDC Volts,

Click here for Parts

31705-0094 information Datasheet


Parts and Accessories for Jabsco model 31750-0000


Major Overhaul Kit / Rebuild Kit :

Catalog # 18920-9053, Service Kit For 31750-0000 & 31755-0000 Series, includes Valve Kit, Diaphragm Kit, Lower Housing Kit & Slide Port Clips

$ 86.34

Applications

Features • Variable Speed Control • Solid State Pressure Sensor • Nearly Silent Operation / No Cycling • Operates on 12V DC or 24V DC • Controls Pressure by Changing Motor Speed • Speeds Up As Demand Increases • Selfpriming / Runs Dry • No Accumulator Tank Needed • CSA Listed / EN ISO 8846 Marine / C.E. Certified • Protected under U.S. Patent 6,607,360 • Includes Inlet Strainer Applications Flow rate 13.716.3 Litres/min 3.74.5 gallons/min Selfpriming from dry up to 2.4m 7.8ft Mount the pump in a dry, ventilated location. The inlet strainer must be installed between the fresh water supply and the pump inlet port. The supply tank should be at least half full prior to initial operation. NOTE The VSD electronics require a battery installed in the DC power supply when using an AC to DC converter or battery charging system. IMPORTANT Polarity of electrical connections is very important. Insure that the RED motor lead is connected to a fused positive DC circuit. The BLACK motor lead must be connected to the negative DC circuit. In the event that polarity is reversed, inline fuse must be replaced.To prime the plumbing system, open all the faucets and turn on the power to the pump. Shut off each faucet as it begins to run free of air. As the last faucet is closed the pump will slow down and shut off.


 

Copyright © 2018 Equipment Agents Inc.