Features:
• The E14 consumes 40% less power than standard circ pumps with 48 frame induction motors the benefit is the energy efficiency of the E14 pump should help with passing the CEC title 20.
• The only pumps to offer “Smart pump” technology that is programmable without requiring a separate controller… i.e. Dry Run Protection and soft start.
• Built in DRY RUN protection is programmed into the software to help eliminate motor and pump damage if the pump is ran without water, not sufficiently primed or is air locked.
• Pumps can be programmed for even greater efficiency by going into sleep mode when the spa heater is not engaged.
• Pump design offers real-time flow reading and therefore can replace the flow switch, pressure switch while providing greater accuracy and reliability.
• Variable speed option is available so the performance can be controlled either by a dial control or by electronic input, i.e. PWM.
• Other programmable features include running waterfalls, sending check filter and maintenance required messages.
• The E14 is quieter, offering a lower overall db level, than traditional induction pumps, eliminating the 48 frame growl.
• The Laing permanent magnet design allows for the capture of 90% of the heat to be transferred into the water versus being lost to the air in waste.
• The Mag drive design has no shaft seals to leak or pump shaft to wear.
• The E series pumps seal with captured O-ring design for the best possible seal.
• The unique electronically commutated 230 volt motor is a global design offering the same performance on 60 Hz or 50 Hz power sources reducing the need to inventory two different pumps and motors.
• Only have to stock one pump to support the global market.
• The E14 weighs less than 4 pounds versus 14 pounds for standard induction pump motors.